DLM1772Y-DLM1775Y Integrated Camera Positioning w/Dual IR Lamps Installation and Operati
STEP 5 Installing the platform - Loosen the four Φ3mm screws on the fixed rotating platform and remove the transformer fixed board mo
1.6 TECHNICAL PARAMETERS 1.6.1 Structure parameters: Integrated pan tilt Aluminum alloy Rotating platform Al
1.6.4 camera, lens parameters 2. OPERATION 2.1 BASIC DESCRIPTIONS After connecting wires as per instructions in previous sectio
When configuring: Configure OK:
STOP SCAN Preset 96 (hit“9”+“6”+ “Preset”) PRESET TOUR Preset 98 (hit“9”+“8”+ “Preset”) AUTO SCAN Preset 99 (hit“9”+“9”+ “Preset”) ZOOM WIDE 1. P
2. 2 PTZ FUNCTIONS This series high-speed P/T camera manual pan speed 0.1 º -100 º/second, manual tilt speed 0.1º ~ 80º/second. Pan
3.11 Auto iris function The camera automatically adjusts iris to keep normal brightness in auto iris mode. Manually operate OPEN o
5.2 SECOND MENU I P/T TYPE COMM PROTOCOL ADDRESS VERSION AUTO EXIT TIME BACK NOTE:
STABILIZER Default Setting: OFF Stabilizer Mode: ON and OFF, Camera with this function displ
5.4 PAN/TILT MENU AUTO FLIP PROPORTIONAL PAN PARK ACTION PARK TIME PRESET TOUR TI
Table of Contents DLM1772Y-DLM1775Y with dual IR Lamps page 1. Installation 3 1.1 Forewo
5.5 POWERING UP ACTION POWER UP ACTION POWER UP TIME BACK POWER UP ACTION
5.8 AUXILLIARY WIPER INFRARED BACK WIPER
6.3 Switch setting for SW2 Note: Switch SW2 is used to set receiving address. Protocol P addresses setting: Switch setting Address SW2-1 SW2-2
Protocols D address setting: Switch setting Address SW2-1 SW2-2 SW2-3 SW2-4 SW2-5 SW2-6 SW2-7 SW2-8 1 ON OFF OFF OFF OFF OFF OFF OFF 2 OFF O
Appendix A TROUBLESHOOTING 1. Image Problem: No image displayed on monitor? →First check if the power supply wire connection, voltage, indic
→DVR control protocol is not compatible with the product or the function is not complete. Problem: why does the same pan tilt h
1. INSTALLATION MANUAL 1.1 FOREWORD This manual introduces the function, installation and operation of the integrated high speed pan tilt camera
Change speed proportionally - Pan/tilt speed and the depth of zoom lens decline proportionally 128 preset position, with accuracy error less th
Steps of pedestal installation: STEP 1 Locate the floor or impending base level that may support 4 times the weight of pan tilt. Fix the screws pr
Connect the cable according to the following pinout diagram: STEP 4 Loosen the four Φ3mm screws on the fixed rotating platform and
Dimensional Drawing: (unit: MM) DLM1778 Pedestal Mount DLM1778 Pedestal Mount * Inver
1.5 WALL INSTALLATION The wall installation camera contains following parts. Inspect each package to make sure all parts are present.
STEP 2 Install the power supply box on the wall if power supply box is required, then install the wall bracket on the power supply b
Comments to this Manuals